HGL Hydraulic Swing Beam Shear
Obtain your desired shear features at a low cost.
HGL Hydraulic Swing Beam Shear
The HGL hydraulic swing beam design shear is a very economical shear with all of the features typically required. The pull down design provides the ability to have a low profile hydraulic shear that is easy to operate by any operator. Shearing capacity is 1/4-inch and shearing length is 6, 8, 10 and 13 foot.
Get in Touch
MAIN FEATURES:
- All welded design providing maximum rigidity and cutting accuracy
- CYBTOUCH 6 touch screen controller for easy programming of the back gauge position and keeping stroke counts. You can use it as a “GO TO” function or program a full part with separate cuts
- 30 inch power back gauge which is ballscrew driven with swing up function
- Full hydraulic holddown system
- Top beam and work table of boxtype construction
- Cylinders are mounted below the bed for a pull down of the upper beam providing short height to see easily behind the shear machine for safety
- Rear safety guarding to prevent access to the back of the shear during operation Shadow line cutting
- Digital stroke counter
- Large quantity of holddowns for maximum holding strength
- Two flat support arms 40 inch in length (Three on 13 foot machines)
- Work table with filler plates, hand slots, and ball transfers
- Back gauge retract function
- Squaring arm of 40 inches with scale, t-slot, and flip stop
- Compact low maintenance hydraulics located underneath the work table
- Foot pedal operation with emergency stop
- Adjustable stroke length for higher speeds when not cutting full length
- Fixed finger light guard
OPTIONS:
- Manual Lubrication
- Squaring arms 10 foot or longer
- Pneumatic rear sheet support system
- Angle gauge for trapezoid cuts
- Powered blade gap adjustment